Samsung SPP4231X-XAC - Manual (Page 32)

32
Storing Channels in Memory (Automatic Method)
1
First, select the correct signal source (Air, STD, HRC
and IRC). See steps on previous page.
Press the MENU button. Press the
▲ or ▼ button to
select “Channel”, then press the ENTER button.
2
Press the ▲ or ▼ button to select “Auto Program”,
then press the ENTER button.
3
Press the ENTER button.
The PDP will begin memorizing all of the available
channels.
After all the available channels are stored, the Auto
program menu reappears. Press the ENTER button to
stop.
Note
• The PDP automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
Air/CATV : Air √
Auto Program √
Add/Delete √
Fine Tune √
Scan √
Channel TV
Move Enter Return
Air/CATV : Air √
Auto Program √
Add/Delete √
Fine Tune √
Scan √
Channel TV
Move Enter Return
Auto Program
Enter Return
Start
➤ ➤
Quick way to access the Automatic Channel Setting: Just press the
“AUTO PROG.” button on the remote control.