Installation of the water dispenser line – Samsung RS2666SL-XAA User Manual

Page 28

Advertising
background image

WATER

ICE

28

2) When you press the test button, the ice cube container is

filled with water from the water supply tap.

Check the amount of water (see the illustration below).

If the water level is too low,

the ice cubes will be small.

This is not a problem with the ice maker

but of the water pressure in

the pipe, and occurs frequently.

When this problem occurs, contact

the dealer service center to check the

amount of water supplied.

INSTALLATION OF THE WATER DISPENSER LINE

Remove any residual matter inside the water supply line after installing filter.

Check the amount of water supplied to the ice tray.

1) Lift up (

①) and pull out (➁) the ice maker bucket in the freezer.

ICE MAKER

1) Turn on the main water supply & shut-off the valve of the

water supply line.

2) Run water through the dispenser until the water runs clear

(6~7 minutes). This will clean the water supply system and

clear air from the lines.

3) Additional flushing may be required in some households.

4) Open the refrigerator door and check if water leaks around

the water filter.

• A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
• Before reinstalling the water filter, remove the wine shelf (RS2666/2777).

NOTE

CHECK THE WATER LEVEL

TEST BUTTON

TOO HIGH

OPTIMUM
LEVEL

TOO LOW

DA68-00500W(0.9) 2005.11.7 21:25 페이지28

Advertising