How to level the refrigerator, How to adjust the door height – Samsung RF32FMQDBXW-AA User Manual

Page 13

Advertising
background image

setting up

_13

01

SETTING

UP

LEVELING THE REFRIGERATOR
AND ADJUSTING HEIGHT AND
GAP OF THE DOORS

HOW TO LEVEL THE REFRIGERATOR

If the Refrigerator is put on a floor that is not level,
it can cause a height difference between the doors.

• Insert a Flat-Head (-) Screwdriver into the slot in

the Leveling Leg Control Lever and adjust the
level by turning the Control Lever clockwise or
counter-clockwise. When you rotate the Lever
clockwise, you raise the refrigerator. When you
rotate the Lever counter-clockwise, you lower
the refrigerator.

• If the Refrigerator is not level back and

front, put a solid panel (such as a plastic
panel, a plastic ruler, etc.) on the floor
where the rear legs will rest, and then fix
it in place with plastic tape. When you
push in the Refrigerator, make sure the
rear legs rest on the panel.

• If you have a wooden floor or similar soft

floor, take care not to damage the floor
when pushing the Refrigerator into place.

flat-blade
screwdriver(-)

Control Lever

HOW TO ADJUST THE DOOR
HEIGHT


If any one of the doors is lower than
the other:
• Check if the Refrigerator is level

before adjusting the door.

• Adjust the door height difference

by inserting a Snap Ring (

1

) as

shown between the door and the
hinge. You can use the rings on the right side
door of the fresh food compartment and both
sides of the freezer compartment.

• After checking the height difference, select one

Snap Ring with a suitable thickness. Insert one
Snap Ring only, Inserting two or more Snap
Rings may cause the Snap Rings to slip out or
make a rubbing noise.

• Lift up the lower door and insert the Snap

Ring into the space between the Door and the
Hinge.

• To avoid injury, insert or remove Snap

Rings carefully.

• Keep the Snap Rings out of the reach of

children and make sure that children do
not play with them or put them into their
mouths.

• 1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap

Rings come with the Refrigerator.

• If the Refrigerator is level before you

load it with food, the Refrigerator may
become unbalanced due to the weight
of the food. If this occurs, adjust the level
again using the same procedure.

• If you raise the door too far, it can rub

against the Top Cover.

Snap Rings included with the refrigerator:

1 mm

1.5 mm

2 mm

2.5 mm

1

CAUTION

DA68-02918A-05.indb 13

14. 6. 25. �� 10:57

Advertising
This manual is related to the following products: