Samsung LS17BIDKSV-EDC - Manual (Page 47)

disappears.
Please change to the recommended mode
during this one-minute period.
(The message is displayed again if the
system is rebooted.)
There is no image on
the screen.
Is the power indicator
on the monitor blinking
at 1 second intervals? The monitor is in PowerSaver mode.
Press any key on the keyboard to activate
the monitor and restore the image on the
screen.
If there is still no image, press the
'SOURCE' button.
Then press any key on the keyboard again
to activate the monitor and restore the
image on the screen.
Is the monitor
connected using the
DVI cable?
You may get a blank screen if you boot the
system before you connect the DVI cable,
or disconnect and then reconnect the DVI
cable while the system is running as certain
types of graphic cards do not send out
video signals.
Connect the DVI cable and then reboot the
system.
I cannot see the On
Screen Display. Have you locked the On
Screen Display (OSD)
Menu to prevent
changes? Unlock the OSD by pressing the MENU
button for at least 5 seconds.
The screen shows
strange colors or just
black and white.
Is the screen displaying
only one color as if
looking at the screen
through a cellophane
paper?
Check the signal cable connection. Make
sure the video card is fully inserted in it's
slot.
Have the screen colors
become strange after
running a program or
due to a crash between
applications?
Reboot the computer.
Has the video card
been set properly? Set the video card by referring to the video
card manual.
The screen suddenly
has become
unbalanced. Have you changed the
video card or the driver? Adjust screen image position and size
using the OSD.
Have you adjusted the
resolution or frequency
on the monitor? Adjust the resolution and frequency of the
video card.
(Refer to the
Preset Timing Modes ).
The screen can be unbalanced due to the cycle of the video card signals.
Readjust Position by referring to the OSD.
The screen is out of
focus or OSD cannot
be adjusted. Have you adjusted the
resolution or frequency
on the monitor? Adjust the resolution and frequency of the
video card.
(Refer to the
Preset Timing Modes ).
LED is blinking but
no images on the
screen.
Is the frequency
properly adjusted when
checking the Display
Timing on the menu?
Adjust the frequency properly by referring
to the video card manual and the
Preset
Timing Modes .
(The maximum frequency per resolution
may differ from product to product.)
There are only 16
colors shown on the
screen.
The screen colors
have changed after
changing the video
Have the Windows
colors been set
properly? Windows ME/2000/XP:
Set the colors properly at the Control
Panel → Display → Settings.
Has the video card
been set properly? Set the video card by referring to the video
card manual.