Appendix, Troubleshooting, Operation ranges – Samsung AW15ECB8XAA User Manual

Page 21

Advertising
background image

appendix

_21

appendix

TROUBLESHOOTING

Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary
expense of a service call.

PROBLEM

SOLUTION

The air conditioner

does not start operating

immediately after it has

been turned on.

Because of the protective mechanism, the appliance does not start

operating immediately to keep the unit from overloading.

The air conditioner will start in 3 minutes.

The air conditioner does

not work at all.

Check that the power plug is properly connected. Insert the power plug

into the wall socket correctly.

Check if the circuit breaker is switched off.
Check if there is a power failure.
Check your fuse. Make sure it is not blown out.

The temperature does

not change.

Check if your air conditioner to make sure it is not operating in Fan mode.

The cool(warm) air does

not come out of the air

conditioner.

Check if the set temperature is higher (lower) than the current

temperature. Press the

Temp button on the remote control or Temp.

button on the control panel to change the set temperature.

Press  or  to increase or decrease the temperature.

Check if the air filter is blocked by dirt. Clean the air filter every two weeks.
Check if the air conditioner has just been turned on. If so wait 3 minutes.

Odors permeate the

room during operation.

Check if the appliance is running in a smoky area or if there is a smell

entering from outside. Operate the air conditioner in Fan mode or open

the windows to air out the room.

Check your ventilation lever and make sure it is in position. Outside

odors might come in when your ventilation lever is in position.

The air conditioner

makes a bubbling sound.

A bubbling sound may be heard when the refrigerant is circulating through

the compressor. This is normal operation.

The air conditioner

vibrates excessively

or makes a lot of noise

during operation.

Check if there is a gap between the air conditioner and the wall. Insulate

the crack securely.

Water is dripping from

the air flow blades.

Check if the air conditioner has been cooling for an extended period of

time with the air flow blades pointed downwards. Condensation may

generate due to the difference in temperature. Push the vertical air flow

blades upward and run the appliance.

Remote control is not

working.

Check if your batteries are depleted.
Make sure batteries are correctly installed.
Make sure nothing is blocking the remote control sensor.

OPERATION RANGES

The table below indicates the temperature and humidity ranges the air conditioner can be operated within.
Refer to the table for efficient use.

MODE

OPERATIONAL TEMPERATURE

INDOOR HUMIDITY

INDOOR

OUTDOOR

COOLING

Approximately 70˚F~90˚F Approximately 70˚F~110˚F

80% or less

Advertising
This manual is related to the following products: