Samsung DMR77LHW-XAC - Manual (Page 11)

installing the dishwasher _11
02 I
NST
A
ll
ING
T
he d
IS
h
W
AS
her
STep  PrePArING The dIShWASher
1. Ensure that the circuit breaker and water supply valve are turned off before proceeding with
the following steps.
. Ensure that the kick plate is placed on the cushion front, and make sure to keep it.
. Install the 90˚ elbow at the Inlet valve. When inserting the elbow into the Inlet valve, use Teflon
tape or sealing compound to prevent water leakage.
To prevent blocking the inlet valve, make sure that the Teflon tape or sealing compound does
not enter the valve.
. Remove the junction box cover located at the bottom right at the front of the dishwasher
using a screwdriver and then Install the strain relief. Make sure to keep the junction box cover
you removed as it is used in STEP 10.
. When the countertop is made of wood or a material that is not damaged by drilling, locate
the two (2) Installation brackets that were supplied with the dishwasher. (Refer to the figures
in STEP 8.)
<figure >
<figure >
A
B C
C
B
A
Junction
box
Strain relief
Kick plate