Audiovox CE710CR - Manual (Page 15)

11
DOCKING 1 st AND 2 nd GENERATION iPod NANOS
First, install the iPod ® Nano bracket into the CE710CR dock.
1st Generation iPod nano:
Align your 1st generation iPod ® Nano to the LEFT side of the opening in the
nano bracket (Figure 1 ). Make sure the 30-pin connector on the bottom of the
nano is positioned over the connector in the CE710CR dock prior to seating the
nano. Carefully slide the nano down onto the connector in order to insure a
secure connection.
2nd Generation iPod nano:
Align your 2nd generation iPod ® Nano in the RIGHT of the opening in the nano
bracket (Figure 2 ). Make sure the 30-pin connector on the bottom of the nano
is positioned over the connector in the CE710CR dock prior to seating the
nano. Carefully slide the nano down onto the connector in order to ensure a
secure connection.
Note: Be careful not to damage the connector when docking the nano. Never use force when
docking the nano onto the connector.
Figure 1
Figure 2