Arcam Pre Amplifier P35 - Manual (Page 14)

14 14 15
E
n
g
li
sh
Technical specifications
NOTE: All specification values are typical unless otherwise stated.
CONTINUAL IMPROVEMENT POLICY
Arcam has a policy of continual improvement for its products. This
means that designs and specifications are subject to change without
notice.
C30 P35 P1
Continuous power output (20Hz—20kHz at 0.5% THD), per channel
Both channels, 8Ω, 20Hz—20kHz
100W
Single channel, 8Ω, 20Hz—20kHz 150W 170W
Both channels, 4Ω, 20Hz—20kHz 140W
Single channel, 4Ω, at 1kHz 200W 250W
Three channels, 8Ω, 20Hz—20kHz 90W
Harmonic distortion, 80% power, 8Ω at 1kHz 0.005% 0.003%
Inputs
Phono cartridge:
Input sensitivity
2.7mV (MM); 270µV (MC)
Input impedance 47kΩ (MM); 300Ω (MC)
Signal/noise ratio (CCIR) –79dB (MM); –73dB (MC)
Overload margin 35dB
Line and tape inputs:
Nominal sensitivity
250mV—2V 800mV
Input impedance 22kΩ 22kΩ
Signal/noise ratio (CCIR) –103dB –110dB
Tone controls, max. boost/cut ±12dB @ 80Hz and 12kHz
Power amplifier input
Nominal sensitivity
800mV 906mV (Arcam gain)
Input impedance 22kΩ 22kΩ
Gain 31.5dB 31.5dB (Arcam gain)
Preamplifier output
Nominal output level
700mV
Maximum output level 8V RMS
Output impedance <50Ω
Headphone output
Maximum output level into 600Ω
5V
Output impedance 4.7Ω
General
Mains voltage
115V or 230V 115V or 230V 115V or 230V
Power consumption (maximum) 30VA 800VA (950VA for P35/3) 800VA
Power consumption (standby) 2VA 2VA 2VA
Dimensions W x D x H (including feet) 430 x 370 x 110mm 430 x 350 x 110mm 430 x 350 x 110mm
Weight (net) 9.3kg 9.5kg (10.5kg for P35/3) 12.5kg
Weight (packed) 11.5kg 12.5kg (13.5kg for P35/3) 15.5kg
Supplied accessories mains lead
CR-389 remote control
2 x AAA batteries mains lead mains lead
E&OE