Samsung BD-P1000-XAA - Manual (Page 18)

18 - English
C
onnecting
Choosing a Connection
The following shows examples of connections commonly used to
connect the Blu-ray disc player with a TV and other components. You may choose from VIDEO, S-VIDEO, COMPONENT
and HDMI mode for video output.
Use the TV OUT SELECT button on the front panel of the
unit to select the video output while the disc is stopped.
- Video Output mode changes as follows when the
TV OUT SELECT button is pressed: HDMI ➞ VIDEO ➞
COMP
➞
HDMI order.
- To select HDMI output, press the TV OUT SELECT
button until the HDMI indicator lights.
- To select COMPONENT output, press the TV OUT
SELECT button until the COMP indicator lights.
- To select VIDEO or S-VIDEO output, press the TV OUT
SELECT button until the VIDEO indicator lights.
Connecting to a TV(Video)
1. Using video/audio cables, connect the VIDEO
(yellow)/AUDIO (red and white) OUT terminals on the rear
of the Blu-ray disc player to the VIDEO (yellow) /AUDIO
(red and white) IN terminals of your TV.
2. Turn on the Blu-ray disc player and TV.
3. Press the TV OUT SELECT button on the front panel
of the unit until the VIDEO indicator lights. Make sure
the unit is in Stop mode.
4. Press the input selector on your TV remote control
until the Video signal from the Blu-ray disc player
appears on the TV screen.
• If you have set the remote control to properly operate
with your TV (pages 15~16), press the INPUT SEL.
button on the remote control and select VIDEO as the
external source of the TV.
■ Noise may be generated if the audio cable
placed too close to the power cable.
■ If you want to connect to an Amplifier,
please refer to the Amplifier connection
page. (See pages 21 to 22)
■ The number and position of terminals may
vary depending on your TV set. Please refer
to the user's manual of your TV.
■ If there is one audio input terminal on the TV,
connect it to the [AUDIO OUT][left] (white)
terminal of the Blu-ray disc player.
■ If you set the TV Out Select to HDMI, the
Video/S-Video and Component Out
terminals will not output any signal.
■ Blu-ray Disc Playback is not available with
this connection.
NOTE
■ If HDMI mode is selected for TVs providing
display information (EDID), the TV resolution
will be automatically changed to the best
quality supported by the TV.
■ If HDMI mode is selected for TVs that do not
provide display information (EDID),
resolution will be adjusted to 720p.
■ If COMP (Component) mode is selected,
resolution will be adjusted to 480p.
■ If VIDEO mode is selected, resolution will be
adjusted to 480i.
■ Only resolutions supported by the TV are
available.
■ Select the resolution from <Setup> ➞
<Display Setup>. (See page 43.)
NOTE
TV Output Selection
Feature