Samsung WB09H7300GP-A1 - Manual (Page 8)

English - 8
Accessories
The water supply hose and the drain hose (extension hose) can be purchased at a local Samsung
service center.
Water supply hose
(2)
Drain hose Short inlet hose (2) “Y”-connector (2) Hose guide
Drain adaptor Baffle board Leveling device Screw Clamper
Rubber washer (2) User manual Tap connector
Installation requirements
Water Supply
• To correctly fill your washer in the proper amount of time, water pressure of 20 to 116 psi (137
to 800 kPa) is required. Water pressure less than 20 psi may cause water valve failure, may
not allow the water valve to shut off completely, or may extend the fill time beyond what your
washer controls allow, causing your washer to turn off. A time limit is built into the controls to
prevent flooding in your home if a hose becomes loose.
• For the provided water hoses to reach the washer, make sure the water taps are within
120 cm (4 ft) of the back of the washer.
• Before using for the first time, check all connections at the water valves and taps for any leaks.
To reduce a risk of water leaks:
• Make sure the water taps are easily accessible.
• Turn off the water taps when the washer is not in use.
CAUTION: Check all connections at the water valves and taps for any leaks.
Untitled-2 8 2014-05-26 �� 10:51:09