Samsung DVDV2500V-XAA - Manual (Page 27)

Digital Output
27
If your A/V receiver is equipped with a Dolby Digital decoder, your
DVD-VCR can output Dolby Digital 5.1 sound, but you MUST
enable this feature in the menu system to prevent damage to your
speakers.
NOTE: Select “Bitstream” ONLY if you have connected a Dolby
Digital-equipped A/V receiver to the Digital Output
(optical or coaxial) on the DVD-VCR back panel.
1 Open “SETUP MENU”
With the DVD in stop mode, press the SETUP button.
2 Select “DVD Setup”
Using the up and down buttons, move the selection cursor to “DVD
Setup,” then press ENTER to select.
3 Set “Digital Output”
Move the selection bar to “Digital Output” then press the right/left
button to select from the following options:
• PCM - To use your DVD/TV with an A/V receiver NOT equipped
with a Dolby Digital decoder.
• Bitstream – To use your DVD/TV with an A/V receiver equipped
with a Dolby Digital decoder.
P C M
B i t s t r e a m