Samsung DV457GVGSGR-AA - Manual (Page 36)

English - 36
Drying a load of laundry
Using the My Cycle function
The My Cycle function lets you to save up to 3 custom drying cycles with their drying level and
temperature settings and then recall and run those cycles with the push of a button.
Saving a My Cycle
Follow the steps below to save your a favorite custom dry cycle as a My Cycle.
1. To begin, we’ll assume that there are no saved
My Cycles. If this is the case, when you tap
the My Cycle button in the Cycle Selection
screen, it will expand and show a list of 3 None
buttons (None1to None3) as shown in the
fi gure, right.
2. Select a cycle with its drying level and
temperature setting.
Refer to the “Cycle chart” section on page
68 for available drying levels and temperature
setting for each cycle.
3. Tap the Save As My Cycles button located at
the right center of the Cycle Selection screen.
4. Select the My Cycle you want to overwrite
with the selected cycle and its options. In this
example, We’ll select My Cycle 1: None. Then
tap the Next button.
5. The Save as new name screen is displayed.
Enter the name you want to give the My Cycle.
In this example, We’ll enter “J’s Wash”. Then
tap the Save button.
6. A summary of the My Cycle that will overwrite
the existing one (None1 in this example) is
displayed, as shown in the fi gure, right. Tap the
OK button.
7. The My Cycle “None1” is changed to “J’s
Wash” in the My Cycle list of the Cycle
Selection screen.
DV457E(G)_02836E-08_EN.indd Sec3:36 DV457E(G)_02836E-08_EN.indd Sec3:36 2014-04-28 6:13:19 2014-04-28 6:13:19