Samsung WA50F9A7DSP-A2 - Manual (Page 11)

ALIGNMENT AND ADJUSTMENTS
11
Demo Mode
- Demo mode is entered when the Pre Soak + Extra Rinse buttons are held down for five (5)
seconds simultaneously in the power on state.
- When entering Demo mode, the buzzer rings three (3) times and “- - - -” is displayed on the 7
segment display and all other LEDs are turned off. (Initial Demo mode)
- Demo mode consists of WASH, SPIN and LED modes.
- If the Temp. button is pressed during the initial Demo mode, “USH” blinks on the 7 segment
display and the washing machine enters WASH mode.
- If the Start/Pause button is pressed in WASH mode, the door is locked (Door Lock) and the motor
rotates left and right at 110 RPM in a 1.1sec on and 1.3sec off cycle.
- WASH mode continues up to five (5) minutes once started. After the five (5) minutes have
elapsed, “- - - -” is displayed on the 7 segment display and the initial Demo mode is maintained.
- If the Start/Pause button is pressed during a WASH mode operation, “- - - -” is displayed on the 7
segment display and the initial Demo mode is maintained.
- If the Spin button is pressed in the initial Demo mode, “SPn” blinks on the 7 segment display and
the washing machine enters SPIN mode.
- If the Start/Pause button is pressed in the SPIN mode, the door is locked (Door Lock) and a spin
is operated at 1030 RPM .
- SPIN mode continues up to four (4) minutes once started. After the four (4) minutes have
elapsed, “- - - -” is displayed on the 7 segment display and the initial Demo mode is maintained.
- If the Start/Pause button is pressed during a SPIN mode operation, “- - - -” is displayed on the 7
segment display and the initial Demo mode is maintained.
- If the Soil Level button is pressed in the initial Demo mode, “LEd” blinks on the 7 segment
display and the washing machine enters LED mode.
- If the Start/Pause button is pressed in LED mode, all LEDs are turned on. The LED mode
continues up to thirty (30) seconds once started. After the thirty (30) seconds have elapsed, “- - -
-” is displayed on the 7 segment display and the initial Demo mode is entered.
- If the Start/Pause button is pressed during an LED mode operation, “- - - -” is displayed on the 7
segment display and the initial Demo mode is entered.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
Pre Soak + Extra Rinse
3sec
While a cycle is not running
F900A WASH_WA50F_ MANUAL_DC68-03132C_EN（需要翻译的文件）.indd 11 2013-1-21 14:58:16