Samsung SCH-R300ZKAXAR - Manual (Page 62)

59
• If the recording was good, say “Yes.”
• If you need to re-record, say “No.”
If you say “No”, the phone prompts you to pronounce the
digits again. Wait for the beep and then say the digits.
Repeat this step until you’re satisfied with the recording.
4. After confirming that the recording sounds “ok”, continue
the recording process with the next set of digits.
5. After 10 sets of digits, the phone asks whether you want to
do more adaptation. Answer “Yes.”
6. Repeat steps 4 and 5 for another 10 sets of digits. After the
second group of 10 sets of digits, “Adaptation complete”
plays through the speaker and you are returned to the Digit
Dialing menu.
Reset Digits
To reset digit dialing to factory default settings, do the following:
1. In standby mode, press MENU, then select Voice SVC ➔
Voice Settings ➔ Digit Dialing ➔ Reset Digits. The phone
prompts you to confirm digit reset.
2. Press OK or to reset your digit adaptation, or press
Back or to cancel.
Sound
Sound lets you specify what (if any) text prompts you want your
phone to read to you through the earpiece.
1. In standby mode, press MENU, then select Voice SVC ➔
Voice Settings ➔ Sound. The following options appear in
the display:
• Prompts — On/Off — Enables or disables audio prompts.
• Digits — On/Off — Enables or disables digit playback.
• Names — On/Off — Enables or disables name playback.
• Name Settings — Lets you adjust the Speed (Faster or Slower)
and Volume (Louder or Softer) of your phone’s audio name
playback.
2. Select the desired option and setting. Press to
discard the new setting and return to the Voice Settings
menu.
Voice Launch
To set the key or action that launches VoiceSignal, do the
following:
1. In standby mode, press MENU, then select Voice SVC ➔
Voice Settings ➔ Voice Launch.