Allied Telesis AT-WA1004G - Manual (Page 73)

AT-WA1004G User’s Guide
73
Connection Status - L2TP
If using L2TP, a screen will be displayed when the “Connection Details”
button is clicked.
Data - L2TP Screen
Connection
Physical Address The hardware address of this device, as seen by
remote devices on the Internet. (This is different to
the hardware address seen by devices on the local
LAN.)
IP Address The IP Address of this device, as seen by Internet
users. This address is allocated by your ISP
(Internet Service Provider).
Connection
Status This indicates whether or not the connection is
currently established.
❏ If the connection does not exist, the “Connect”
button can be used to establish a connection.
❏ If the connection currently exists, the
“Disconnect” button can be used to break the
connection.
Connection Log
Connection Log
❏ The Connection Log shows status messages
relating to the existing connection.
❏ The “Clear Log” button will restart the Log,
while the Refresh button will update the
messages shown on screen.
Buttons
Connect If not connected, establish a connection to your
ISP.
Disconnect If connected to your ISP, hang up the connection.
Clear Log Delete all data currently in the Log. This will make
it easier to read new messages.
Refresh Update the data on screen.