Samsung HPP5091X-XAA - Manual (Page 36)

36
Storing Channels in Memory (Automatic Method)
1 First, select the correct antenna (Air and Cable).
See steps on previous page. Press the MENU button.
Press the ▲ or ▼ button to select “Channel”,
then press the ENTER button.
2
Press the ▲ or ▼ button to select “Auto Program”,
then press the ENTER button.
➤ ➤ Quick way to access the Automatic Channel Setting:
Just press the “AUTO PROG.” button on the remote control.
3 Press the ▲ or ▼ button to select the correct signal
(Air, STD, HRC, and IRC). Select an option and then
press the ENTER button.
If you are connected to an antenna (Air), leave
“Air” displayed. If you are connected to a cable,
press the ▲ or ▼ button to display the type of cable
system “STD”, “HRC” or “IRC”. (If you are not sure
which type of cable system you have, contact your
cable company).
4 Press the ENTER button.
The PDP will begin memorizing all of the available
channels. After all the available channels are stored,
the Auto program menu reappears. Press the MENU
button to stop.
Note
• Auto Program may take a few minutes to process.
Select Antenna : Air √
Auto Program √
Add/Delete √
Fine Tune √
Signal Strength √
Channel TV
Move Enter Return
Select Antenna : Air √
Auto Program √
Add/Delete √
Fine Tune √
Signal Strength √
Channel TV
Move Enter Return
Air
STD
HRC
IRC
Auto Program TV
Move Enter Return
Start
Auto Program
Enter Return
Air Ch 23
Stop
Auto Program
Enter Return
It will take about several minutes.
Would you like to continue?