Samsung RS2530BWP-XAC - Manual (Page 23)

2) Please adjust the height difference between the doors by turning the bolt ( ➁) clockwise ( ) or
counter clockwise ( ).
23
INST
ALLA
TION INSTR
UCTIONS
ADJUSTING THE HEIGHT BETWEEN THE DOORS
Making small level adjustments between doors.
If the door of the freezer is lower than that of
the fridge. If the door of freezer is higher than that of the
fridge.
3) After adjusting the doors, turn the nut clockwise ( ) until it reaches the lower end of the
bolt, then tighten the bolt again with the wrench ( ➂) to fix the nut(①).
If you do not fix the nut ( ①)firmly, the bolt (➁) may be released.
Adjustment part Adjustment part
➂ WRENCH ➂ WRENCH
➀ NUT
➀ NUT
➁ BOLT ➁ BOLT
➀ NUT
➁ BOLT
➂ WRENCH
➂ WRENCH
➁ BOLT
Please open the doors and adjust them as follows:
1) Release the nut (
①) on the lower hinge until it reaches the upper end of the bolt (➁).
When you release the nut ( ①), use enclosed hex wrench (➂) to turn the bolt(➁) in a slightly
counterclockwise direction. This will enable you to loosen the nut( ①) with your fingers.
When you turn clockwise ( ), the door goes up.
NOTE
NOTE
NOTE
➀ NUT
➂ WRENCH
➀ NUT
➁ BOLT
➂ WRENCH
➀ NUT
➁ BOLT
DA68-01606B(0.0)-EN 2/28/07 3:24 PM Page 23