Samsung SCH-R250ZRAMTR - Manual (Page 52)

48
Voice Method
Use the Voice SVC Lookup command to view contact information for
any named contact stored in your Contacts list by saying the name.
Note: The Lookup command shows the requested contact information in the
display but does not dial any phone numbers for the contact.
1. In Standby mode, press and hold to launch Voice SVC.
“Say a Command” appears in the display and is pronounced
through the speaker.
2. Say “Lookup”.
Voice SVC prompts you to “Say the name.”
3. Speak clearly and say the full name of the person you want to
call, exactly as it is entered in your Contacts list.
• If VoiceSignal recognizes the name you said, the Contact information for
that name appears in the display.
• If VoiceSignal does not recognize the name you said, a choice list of up to
three names appears in the display, and VoiceSignal prompts you with
“Did you say?” followed by the first name on the list.
4. Say “Yes” to confirm the name or “No” to hear the next name,
or use the keypad to select the correct name from the list. (See
“Choice Lists” on page 118, for more information.)
• To say the name again, press Repeat.
• To exit VoiceSignal without dialing, press
.