Samsung VCC88P0H1B-XAA - Manual (Page 7)

operating the vacuum _7
02 OPERA
TING THE V
ACUUM
- BODY
Press the power ON/OFF button repeatedly to start
and to stop the vacuum cleaner.
(OFF → ON → OFF)
If the remote handle control is not working, the
cleaner can be operated using the ON/OFF
button on the body of the machine.
1 The ON/OFF button operates the vacuum cleanner or stops it.
2
The RADIO FREQUENCY light indicates the part that receives the
RADIO FREQUENCY signal from the handle control.
3
The fi lter light is illuminated when the dust pack requires checking or
emptying. An audio signal will also sound.
1
3 2
POWER CONTROL
1. Vacuum cleaner ON/OFF( )
Press the ON/OFF button to operate the
vacuum cleaner. Press again to stop the
vacuum cleaner.
2. Vaccum cleaner suction(-/+)
Press the SUCTION (+/) button to increase
or decrease the suction power. Each time
you press the button, you gradually increase
the suction power. After the suction power
reaches its maximum, the next time you press
the button, you return the suction power to its
minimum.
3. BRUSH ON/OFF
Press the BRUSH ON/OFF button to operate the Power Brush. Press again to stop the
Power Brush.
Don’t cover the handle transmitter when you use a handle control button.
FCC NOTICE
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation.
RADIO FREQUENCY REMOTE-CONTROL
- HOSE
Handle Control
The cleaner is controlled by radio
frequency signals.
transmitter
DJ68-00597P(0.1)-POWER.indb 섹션4:7 DJ68-00597P(0.1)-POWER.indb 섹션4:7 2012.6.21 6:18:51 PM 2012.6.21 6:18:51 PM