Samsung DVD-AR650-XAA - Manual (Page 16)

C
onnecting & Setting Up
English - 16
Antenna + Cable box or satellite receiver (set top box) + DVD Recorder + TV :
Cable box/Satellite receiver with a video/audio output
You can record channels by selecting the channel on the cable box or satellite receiver (set top box).
You cannot record one channel while watching another channel. Be sure that the cable box or satellite receiver
(set top box) is turned on.
▌
Connecting the IR Blaster cable into the Cable Box Control jack
The Cable Box Controller (IR Blaster) is used to control
your cable box for recording purposes.
1. Find and Connect the included IR Blaster cable into the
Cable Box's Control jack of the DVD Recorder.
2. Find the Cable Box IR Sensor
A. Turn the cable box Off.
B. Hold the Cable box/Satellite receiver's remote so that
it touches the front of the Cable box/Satellite receiver
(see Figure 1).
C. Move the Cable Box's remote across the front of
the Cable Box/Satellite Receiver while pressing the
remote's power button On and Off (Figure 2).
(Press and release the power button each time you
move the remote; holding down the button will not work.)
D. When the Cable box/Satellite receiver powers On,
you have found the sensor.
E. Remember the location of the sensor.
3. Place the IR Blaster.
Place the Cable box controller of the IR Blaster on
top or underneath the Cable box/Satellite receiver
approximately 1 inch in front of the sensor you found in 2.
Use the double-sided tape to secure the IR Blaster.
You must select a Cable box/Satellite receiver
brand from the table on pages 81~83. If you do
not know the brand name, please contact your
cable/satellite provider.
After setting up your cable box or satellite receiver
(Set top box) with the DVD recorder through the
IR Blaster cable, you need to set up the Set Top Box
Control menu. (See pages 32~33) ■
■
Figure 2
Correct
Figure 1
Incorrect
01378A-AR650-XAA-ENG.indb 16 01378A-AR650-XAA-ENG.indb 16 2007-03-13 오전 11:54:24 2007-03-13 오전 11:54:24