Samsung HT-D6500W-ZA - Manual (Page 22)

22
English
Connections
CAUTION
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands
or alien substances into the duct (hole) of the subwoofer speaker.
Do not hang the subwoofer on the wall through the duct (hole).
Do not insert any other card except the TX card dedicated to the product.
If you insert a different TX card, you can damage the product and may not be able to remove the
card easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may
cause a problem.
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
If no sound is heard from the wireless surround speakers, switch the mode to Dolby Pro
Logic
II.
In 2-CH mode, you will hear no sound from the wireless surround speakers.
NOTE
If you place a speaker near your TV set, the screen color may be distorted because of the magnetic
fi eld.
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is
too close to the product, sound from the speakers may be disrupted because of interference.
If you use a device such as a microwave oven, wireless LAN Card, or any other device that uses
the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted
because of interference.
The maximum transmission distance from the product to the wireless receiver module is about 33
feet (10m), but may vary depending on your operating environment. If a steel-concrete wall or
metallic wall is between the product and the wireless receiver module, the system may not operate
at all, because the radio wave cannot penetrate metal.
If the product doesn't make a wireless connection, you need to run an ID Set between the
product and wireless receiver module. With the product turned off, press "0"
"1""3""5" on
the remote control. Turn on the wireless receiver module. Then, press and hold the "ID SET"
button on the back of the wireless receiver module for 5 seconds, and then turn the product on.
Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit
If you attach a Toroidal ferrite core to the power cord of the man unit, it will help to prevent RF
interference from radio signals.
Pull the fi xing tab of the Toroidal ferrite core to
open it.
Make a loop twice in the main unit power
cord.
Attach the Toroidal ferrite core to the main unit
power cord as the fi gure shows and press it until it
clicks.
!











✎





1.
2.
3.
FRONT
SPEAKERS OUT
SPEAKER IMPEDANCE : 3
FM ANT
WIRELESS VIDEO OUT AUX IN
SUBWOOFER
CENTER FRONT
COMPONENT OUT
HT-D6500W_XAA_1226.indd 22 HT-D6500W_XAA_1226.indd 22 2011-12-26 4:11:04 2011-12-26 4:11:04