Autostart AS-1291 - Manual (Page 4)

P. 4 User Guide
Caution: do not turn the key to the
CRANK
position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-
Grind Feature (Optional).
Remote Starter Features
Idle Mode
This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
IGNITION
switch. The vehicle will keep running for the pre-
programmed run time, or until it is shut down by remote.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
Idle Mode can be activated through the same routine as that used for Ready Mode; at the
last step, the
Ι & ΙΙ button are pressed together.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the
user leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds
(or until it is shut down by remote control), then shut down the engine.
Turbo Mode can be activated only if button
Ι is programmed as
LOCK or UNLOCK button.
Turbo Mode is activated through the same routine as that used for Ready Mode; at the last
step, the
Ι button is pressed.
Valet Modes
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn
on
solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn
OFF
.
Valet Mode Using the Valet Button
(Available only of the plug-in Valet switch is installed)
To put the system into Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Press (for at least 1 second) and release the Valet Button. The parking lights will
flash 3 times. Turn the ignition key to
OFF
position and the L.E.D. will
come on.
To take the system out of Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Press (for at least 1 second) and release the Valet Button. The parking lights will
flash twice. Turn the ignition key to
OFF
position and the L.E.D. will go
OUT
.
The Valet button can only be used if the vehicle keys are in the
IGNITION ON (RUN)
position.