A4tech Wireless Optical Zoom Mouse User Manual
Page 4
Wireless Optical Zoom Mouse
- 3 -
Selecting the Frequency Channel
The RF-Mouse operates on two frequency channels. To prevent interference when
using two RF Mice in close proximity, a different frequency channel should be
used for each mouse. Refer to the following instructions to change the frequency
channel for your mouse:
1. Set the frequency channel
(B)
on the receiver to 1 or 2.
2. Remove the battery cover from the mouse (see the following Inserting the
Batteries section).
3. Set the frequency channel
(L)
on the mouse to 1 or 2. (The frequency channel
for mouse and receiver must be the same).
Inserting the Batteries
The RF-Mouse uses two batteries. Refer to the following to insert the batteries:
1. Press the tab on the bottom of the mouse cover as shown here and remove
the cover.
2. Insert the two batteries. (The correct polarity is indicated on the battery
compartment casing.)
3. Replace the cover.
L
L
B
PDF 檔案以 "FinePrint pdfFactory Pro" 試用版建立