Samsung RR3773ATCSR - Manual (Page 12)

12_ setting up
REVERSING THE
REFRIGERATOR DOOR
Samsung recommends that reversing of
the door opening is only completed by
Samsung approved Service providers.
This will be on a chargeable basis and at
the customers expense.
Any damage caused while attempting to
reverse the door opening is not covered under
the appliance manufactures warranty.
Any repairs requested due to this circumstance
will be completed on a chargeable basis at the
customers expense.
Required Tools (Not provided)
Phillips Head
Driver (+)
Flat Head
Driver (-)
10 mm Socket
Wrench
(for bolts)
8 mm
Socket Wrench
(for bolts)
Spanner
(for hinge shaft)
4 mm Hex
Wrench
(for bottom
hinge shaft)
1. Remove 2 screws on the top of the refrigerator.
2. Remove the plastic cover and make sure to
disconnect the wire connected to it.
After removing the plastic cover, check the parts
for reversing the door.
Be careful not to damage the electrical
wires when removing the plastic cover.
3. Disconnect the wires and then remove 3 bolts.
Make sure your refrigerator is unplugged
before handling electrical wires.
4. Remove the door from the lower hinge by carefully
lifting the door straight up.
Refrigerator door is heavy, be careful
not to injure yourself when removing the
refrigerator door.
5. Separate the front leg cover after removing
2 screws.
6. Unscrew 3 bolts tightening the hinge and also
unscrew 3 bolts on the bottom left side by the front
leg where removed hinge will be attached.
WARNING
CAUTION
Screw
WARNING
CAUTION
Screw
10mm
10mm
DA68-02933A-00.indb 12 DA68-02933A-00.indb 12 13. 5. 28. 7:09 13. 5. 28. 7:09