Audioaccess AVR21EN - Manual (Page 2)

Audio
▲ 70 Watts x 2 stereo mode
▲ 70 Watts x 7 multichannel mode
▲ Two AM/FM tuners
▲ Six rear-panel analog inputs; one front-panel
analog input
▲ Four rear-panel digital inputs: two optical,
two coax; front panel: one coax, one optical
▲ EzSet/EQ; includes microphone
▲ Surround modes include: Dolby
® Digital EX,
Dolby Pro Logic ® II, Dolby Pro Logic IIx,
Dolby Headphone, DTS, ® DTS Neo:6, ®
Logic 7 ® and more
▲ Additional 7.1-channel DVD audio input
▲ 7.1-Channel preamp outputs
▲ Flash-upgradeable
Video
▲ Seven rear-panel composite and S inputs;
one front-panel composite and S input
▲ Five rear-panel component video inputs;
one front-panel component input
▲ DCDi by Faroudja ® upconverter scales all
inputs to 1080i via HDMI ™ output and
480P via component output
▲ Composite video camera input
Controller
▲ On-screen programming for all AVR and
whole-house functions
▲ Six dedicated IR outputs with built-in IR library
and front-panel IR learning
▲ Three RS-232 source interface ports
▲ Six “Flag In” source status ports
▲ One 12-volt trigger output
▲ One RS-232 port for control of AVR functions
and programming upgrades
▲ One external IR receiver input and loop-
through output
Multiroom
▲ Two multiroom digital audio bus outputs
stream eight digital audio sources and
two-way control signals
▲ Six composite multiroom video outputs
Features
Connector Complement/Preliminary Specifications
Audio Section
▲ Stereo mode: 70 Watts per channel, continuous
average power (FTC), 20Hz – 20kHz, @ <0.1%
THD, both channels driven into 8 ohms
▲ Seven-channel surround modes:
70 Watts per channel, all channels driven,
@ <0.1% THD, 20Hz – 20kHz into 8 ohms
▲ Input sensitivity/impedance
linear (high-level): 200mV/47k ohms
▲ Signal-to-noise ratio (IHF-A): 97dB
▲ Surround system adjacent channel separation –
Dolby ® Pro Logic ® I/II/IIx: 40dB
Dolby ® Digital: 55dB
DTS ® : 55dB
▲ Transient intermodulation distortion (TIM):
Unmeasurable
FM Tuner Section
▲ Frequency range: 87.5 – 108MHz
▲ Usable sensitivity: IHF 1.3µV/13.2dBf
▲ Signal-to-noise ratio (mono/stereo): 70/68dB
▲ Distortion (mono/stereo): 0.2/0.3%
▲ Stereo separation: 40dB @ 1kHz
▲ Selectivity: ±400kHz, 70dB
▲ Image rejection: 80dB
▲ IF rejection: 90dB
AM Tuner Section
▲ Frequency range: 520kHz – 1720kHz
▲ Signal-to-noise ratio: 45dB
▲ Usable sensitivity: Loop 500µV
▲ Distortion: 1kHz, 50% mod 0.8%
▲ Selectivity: ±10kHz, 30dB
Video Section
▲ Television format: NTSC
▲ Input level/impedance: 1V p-p/75 ohms
▲ Output level/impedance: 1V p-p/75 ohms
▲ Video frequency response –
Composite and S-video: 10Hz – 8MHz (–3dB)
Component video: 10Hz – 50MHz (–3dB)
General
▲ Power requirement: AC 120V/60Hz
▲ Power consumption –
Standby: 14W
Idle: 77W
Max (seven channels driven): 768W
▲ Dimensions (H x W x D) –
Product: 6-5/8" x 17-5/16" x 17-1/8"
(168mm x 439mm x 434mm)
Shipping: 10-7/8" x 22-3/4" x 21-3/4"
(276mm x 578mm x 552mm)
▲ Weight –
Product: 25 lb (11.4kg)
Shipping: 32 lb (14.5kg)
Audioaccess
250 Crossways Park Drive
Woodbury, NY 11797
www.audioaccess.com
888.691.4171
Fax: 516.682.3510
©2006 Harman International Industries, Incorporated. All rights reserved.
Part No. AAAVR21ENPI
Audioaccess, Harman International and Logic 7 are registered trademarks,
and W.H.E.N. is a trademark, of Harman International Industries, Incorporated.
DCDi by Faroudja is a registered trademark of Genesis Microchip Inc.
Dolby and Pro Logic are registered trademarks of Dolby Laboratories.
DTS and DTS Neo:6 are registered trademarks of DTS, Inc.
HDMI is a trademark of HDMI Licensing LLC.
Specifications are preliminary and subject to change.