Checkmate Technology MultiRam C The memory card - Manual (Page 11)

2.1
Chapter 2
INSTALLATION
This chapter contains all the information you will need to install your MultiRam
C Card. Package Contents, card care instructions, a physical description, and
instructions for RAM additions and card installation are covered.
U N P A C K I N G T H E M U L T I R A M C C A R D
Check the contents of your MultiRam C package to be sure you have the following
—
This owner’s manual
—
MultiRam C Card
—
Six plastic support posts (2 long and 4 short)
—
A floppy disk, containing:
Side 1
—
AppleWorks memory expansion program
Side 2
—
Utilities which include DOS 3.3 and ProDOS
RAM disk drive emulator programs, and a RAM
test program
- A warranty card
Contact your dealer or Checkmate Technology if anything is missing.
You should fill out and return your warranty registration card as soon as
possible. Only registered owners will be notified of updates to the software
packaged with the MultiRam C Card.
C A R D C A R E
Always ground yourself before handling or touching the MultiRam C Card. Touch
any metal object to discharge static electricity from your body. Static
electricity, which can build up on your body, can damage RAM chips. The 256k
RAM chips installed on your card are more sensitive to damage by stat
electricity than 64~ chips.
Handle the MultiRam C Card carefully, by the edges. Do not flex your card while
handling it as this can lead to weakening of connections.
Avoid touching the connector pins on the bottom of the card. These pins must
kept clean and straight as they are inserted into two sockets on the
motherboard to connect MultiRam C to the Apple. Do not remove the anti—static
foam covering the ends of the pins until you are ready to install the card.
you remove the card from the //c for any reason. reinsert the anti—static to
over the ends of the pins to protect them from damage.