Features and benefits how the air purifier works – Amcor AM-45 User Manual

Page 5

Advertising
background image

GB

5

Features and Benefits

How the Air Purifier Works

Control Panel and Remote Control Operation

1. Plug the unit into a 220-240V mains outlet and

press the POWER (A) button. The unit will start
operating in the lowest speed. The UV lamp and
Ioniser will be on. Note that these are always
the initial conditions when the unit has been
disconnected from the mains power. If the unit
is turned on while having remained connected
to power, it will turn on with the same UV lamp
and Ioniser settings as when it was turned off.
The speed setting will also be kept, if the unit is
turned on with the TIMER (B) button or Remote
Control.

2. With each press on the POWER (A) button, the

unit will cycle through the following sequence:

Speed 1 (Lowest speed), Speed 2, Speed 3, Off, Speed 1… The selected speed will be

indicated by the green light next to the “1”, “2”, or “3” printing.

3. With each press on the IONISER (C) button, the Ioniser will cycle on and off. When the

Ioniser is on, the green light next to the IONISER (C) button is lit.

4. With each press on the UV (D) button, the UV lamp will cycle on and off. When the UV

lamp is on, the green light next to the UV (D) button is lit.

5. The Timer functions, which are controlled by the TIMER (B) button, are as follows:

a. With each press on the TIMER (B) button, the Timer will cycle through the following

sequence:1hr, 2hrs, 4hrs, 8hrs, Timer off (but the unit keeps operating), 1hr…The
selected Timer interval (in hours) will be indicated by the green light next to the “1”,
“2”, “4” or “8” printing.

b. The unit will operate for the selected Time interval (1 hr, 2 hrs, 4 hrs or 8 hrs) and then

turn off the unit. After the appropriate time period has passed the green light will move
to the next lower position in order to show the remaining time.

6. The Remote Control turns the unit on and off (see point 1 above). For long operating

distance the Remote Control should be pointed at the area just below the POWER (A)
button.

D: UV

C: IONISER

B: TIMER

A: POWER

Advertising