Aiwa LCX-107 - Manual (Page 5)

5
En
TUNER OPERATION
1 Press *TUNER/BAND repeatedly to select the
desired band.
The power is turned on and the previously tuned station is
received.
* or BAND on the remote control
2 Press f or g (TUNING DOWN/UP) to
select a station.
After listening, press POWER6STANDBY to turn the power
off.
For quick tuning (auto search)
Keep f or g pressed until the tuner starts searching
for a station. When a station is tuned to, the search stops.
If the broadcast signal is weak, it does not stop. To stop the
search manually, press f or g.
Note
If the unit picks up noise from other electrical appliances
nearby, like a TV or fluorescent lights, move the unit.
*REPEAT/SLEEP/FM MODE/OSC
- If an FM stereo broadcast contains noise, press the button
so that MONO is displayed.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button again.
- If a high-pitched sound is heard during AM recording, press
the button repeatedly until the noise is reduced. Its position
can be checked by “•” being on or off in the display.
* or MODE on the remote control
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step.
If you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the interval as follows.
1 Press TUNER/BAND to display FM.
2 Press s while pressing TUNER/BAND to display the AM
frequency.
When the AM tuning interval is changed, the preset stations
are cleared.
Presetting Stations
You can preset up to 15 stations in each band.
1 Select a station.
2 Press s once so that “M” is displayed to store
the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
3 Repeat steps 1 and 2.
The next station will not be stored if a total of 15 preset
stations have already been stored for a band.
To listen to preset stations
Select a band then press c/aPRESET repeatedly. cPLAY
on the remote control is also available.
To select a preset number directly with the remote
control
Press the numbered buttons 0-9 and +10.
Example:
To select number 15, press +10 and 5.
To select number 10, press +10 and 0.
To clear a preset station
Select the preset number first. Within 4 seconds, keep s
pressed until “M” and the preset number disappear in the
display.
The higher numbers in the band are decreased by one.
Preset number Frequency
LCX-107 (U) Eng 11/21/00, 10:26 AM 5