AFX CCF1912232C930ENSN - Manual

CSC Series
Surface Mounted Fluorescent Fixture
Models 22, 2232
Page 1 of 1 8060068 rev.6
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or servicing any
part of this fixture.
B. Remove fixture from cartoning; remove trim band (2) and
diffuser (3) by removing the 3 thumb nuts (1).
2. Wiring
All wiring must take place inside junction box. Caution :
Make sure power is off at fuse or circuit breaker box. Check power
wires for damage or scrapes. If power supply wires are within three
inches of ballast use wire suitable for at least 90C (194F). Note:
Most dwellings built before 1985 have supply wire rated to 60C.
Consult a qualified electrician before installing.
A. This unit will not operate properly unless connected to a
“grounded” electrical circuit. Electrical shock, over heating,
low or no light output, and shortened lamp life can result if
proper grounding is not done. Securely attach green (or green
and yellow) wire to ground supply wire.
B. Using wire connectors (provided), connect white supply wire to
white ballast lead. Connect black hot supply wire to black ballast lead. Do not mix wires. Pull on each wire lead to make sure
connections are secure. Make certain no bare wires are exposed outside of wire connectors.
3. Mounting
A. Junction Box mounting; Attach fixture channel (6) directly to Junction box through eyelet holes with two #8 –32 x 1” screws
(provided).
4. Lamping
A. Install small lamp (4) around three inner clips (7) and connect the wire harness connector from the ballast to the lamp that
matches the lamp wattage. Install large lamp (5) around three outer clips (8) and connect the remaining wire harness connector
from the ballast to the lamp.
5. Diffuser mounting
A. Slide the diffuser (3) and trim band (2) over the channel (6) and secure with 3 thumb nuts (1) onto threaded offsets (9).
6. Power to the fixture can now be restored
Limited Factory Warranty
AFX Lighting, Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 3 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of
defective fixture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
This product
uses an ENERGY STAR approved ballast. In the event that ballast replacement is required, please contact a qualified electrician.
2232 model shown