AFX WTA232AMV - Manual

WTA WTK Series
Surface Mounted Fluorescent Fixture
Models 217/220/232/240/417/420/432/440
Page 1 of 4 8060188 rev.5
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the fixture (see labels on fixture housing). Model numbers ending in MV
are designed for use in a 120-277VAC, 60Hz fused circuit (do not
use on a dimming circuit); otherwise the fixture is designed for use in
a 110-120VAC, 60Hz fused circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for dry locations only.
Assembly Instructions
1. Preparing for installation.
A.
Disconnect electrical power before installing or servicing any part of this fixture.
B.
After removing fixture from carton, place unit on a flat surface. To gain access to wiring compartment, remove ballast cover
(1) by pressing at the dimples (2) on the channel (5) and rotating up and off.
C.
Remove appropriate knockout(s) (4) for power supply entry.
D.
WTK models - Punch out small knockouts (6) in each end panel of fixture housing (3). Mount the wood end panels (7) to
each metal end with screws (8) provided.
2. Fixture mounting.