AFX BBP620SASCTD - Manual

BBP Series
Fluorescent Pendant
Models 413/420/613/620
Page 1 of 2 8060154 Rev. 6
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture. (See labels on fixture housing).
Models ending in MV power source 120-277V Non-dimmable
Models ending in SCTD power source 120V (Self Ballasted
dimmable CFL) Usable on a dimming circuit with dimmable lamps
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel.
This fixture is intended for use as general lighting in dry or damp
locations.
Assembly Instructions
1. Preparing for installation.
A. Disconnect electrical power before installing or servicing any part of this fixture.
B. Unpack and lay out all of the fixture components in a manner that you can see that you have everything that you
need to fully assemble the fixture.
C. Please loctite all stems with supplied loctite to prevent stems from coming undone.
2. Fixture assembly - Lighting fixture is partially assembled
A. Disassemble entire center section [stems (7, 8), threaded
nipples (6A, B, C, D), swivels (5A.B)].
B. Take the fixture power wires (black and white) and slide them
through the bottom threaded nipple (6D) and the long stem
(8). Thread the stem/nipple on to the fitting (14) on top of the
socket plate until secure.
C. Insert wires through the nipple (6C) and swivel (5B) and
tighten. Slide wires through threaded nipple (15) and insert
nipple through hanger assembly (16) and slide assembly over
nipple.
NOTE: Two 6” and two 12” stems included for
desired height between hanger assembly and canopy.
D. Insert wire through stem (7) and secure to nipple. Slide wires
through short nipple (6B) and secure. Slide wires through top
swivel (5A), canopy (3) and canopy nut. Tighten all. Note:
that it will be easiest to
slide the wire through
each component if the
threaded nipples at the top
of each item are removed.
E. (See Detail A) Hook one
of the aircraft cable
hangers (9) into the slot in
the hanger bracket (10), with the small fitting under the bracket. Secure them
in place with one of the small screws (11) provided. Repeat with the other
cables, brackets and screws.
3. Fixture mounting.
A. (See top of fixture assembly Page 1) Insert 1 ½” screws (2) through slots in mounting bracket (1) and secure to
junction box in ceiling (not provided). Be sure that the two screws mounted to the bracket line up with the holes in the
canopy (3) and point towards the floor. Slide supply wires through the center hole of the mounting bracket.
Detail A