AFX TAP225PCMV - Manual

TAP SERIES
Taylor
Model 225 Ceiling Mounted Fixture
1 of 2 8060509 r0
FIG. 2
DETAIL A
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 120-277V, 50/60Hz circuit. Do
not use on a dimming circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for dry or damp indoor, lighting
locations.
Assembly Instructions
1. Preparing for installation
A. Consult a local licensed electrician or electrical contractor about
installing the fixture if you are not sure about installation.
B. Select a suitable location (for indoor use only).
2. Installing Fixture Mounting Plate (Fig 1) (Fixture Total
Load Weight: 19 lbs)
A. Before you install the mounting plate (3) that is shown in Fig 1,
make sure the two #8 screws, two lock washers and two hex
nuts are installed to the plate (5). Fish the wires from canopy
assembly and wires from junction box through center hole on
mounting plate (3). Align center of mounting plate (3) to
junction box.
B. To rigidly secure the plate; we recommend mounting to a
junction box and using the included support hardware,
consisting of; wood screws (4) and anchors ( included) at the
four ¼” diameter hole locations at both ends of the plate (3).
3. Install Canopy / Stem to Plate Assembly (Fig 1)
A. Align the 2 holes on the canopy (7) to the plate (3). Align the
two #8-32x1inch studs to the holes in the canopy and use the
ball nuts (8) to secure the canopy.
B. Feed the supply wires through the stem (9). Place a bead of
loctite (included) to threads of nipple attached to swivel
assembly and fasten the end of the stem to the nipple that is
attached on the swivel bracket assembly (6). Repeat these
procedures to connect the other stem (without wires) to the
swivel bracket assembly (6). Note: When tightening the stem
to the threads of the nipple from swivel bracket assembly,
make sure that the swivel ball groove is locked in place to
the bracket tab.
4. Channel Assembly (FIG 2 and DETAIL A)
A. Remove #8 screw (20) from channel assembly separating the cover (2) from channel
(1) and set aside.
B. Make sure when mounting channel assembly that the ballast is on the same side as the
stem that has the wires.
Tools Required: Phillips Screwdriver, Adjustable Wrench & Pliers. Hardware Required: Appropriate mounting hardware