Apex Digital AD1118 - Manual (Page 6)

9 10
How to Connect Your Player To A Television
Y Pb Pr
Y Pb Pr
To Progressive Scan Video Input
Red White
To TV Audio L, R Input
Good - Composite Better - S-Video
Yellow
To S-Video Input on TV
Red White
To TV Audio L, R Input
How to Connect your Player To An Amplifier/Receiver
The AD 1118 is ready for use simply by connecting to your TV using the composite or S-Video diagrams below (S-Video cable not included).
Best - Component
For better quality, connect the DVD video player with an optional
S-Video cable if the TV has an S-Video input. Do not connect the
yellow video cable if using an S-Video cable. Connect the supplied
audio (red & white) cables as shown.
To view, cycle through your TV input sources from your TV remote
(Video 1, 2, etc.) to select the source that your DVD player is
connected to.
If there is no picture present, remove any disc from the player.
Press the I/P button on your DVD player’s remote control
repeatedly to access the S-Video Mode. Connect the supplied video (yellow) and audio (red & white)
cables as shown.
To view, cycle through your TV input sources from your TV remote
(Video 1, 2, etc.) to select the source that your DVD player is
connected to.
Yellow
To Tv Video Input
Red White
To TV Audio L, R Input
Connect the optional Component (Y, Pb, Pr) video cables and
audio (red & white) cables to your HDTV/EDTV set as shown.
To view, cycle through your TV input sources from your TV remote
(Video 1,2, etc.) to select the source that your DVD player is
connected to.
Press STOP button then press I/P button repeatedly.
The AD 1118 incorporates the Progressive Scan feature for use with HDTV/EDTV sets for the best possible video quality. Check your
television manual for compatibility to utilize this feature.
IMPORTANT:
Do not connect the Component (Y, Pb, Pr
and S-Video connectors simultaneously.
Note: Use the interlaced setting when using a standard TV. If
you view a black and white distorted picture on your TV,
press I/P (your installation may be interlaced and it may have
been put into Progressive Scan Mode by mistake).
Note: Your Apex DVD Player is equipped with Progressive
Scan Output (Y, Pb, Pr / Component Video Outputs)
otherwise known as 480P (P=Progressive). The 480P image
offers the best quality picture and eliminates virtually all
motion artifacts. This feature is designed for newer EDTV or
HDTV sets only.
Note: To switch back and forth between Interlace and
Progressive Video Mode, press I/P on your remote control
to cycle between the three modes. Please refer to page 18 in
this manual to learn more about this function.
Good Better
Enjoy the dynamic and realistic sound of Dolby Pro Logic
Surround by connecting an amplifier and speaker system
(right and left front speakers, a center speaker, and one or
two rear speakers).
Yellow
To TV Video Input
Surround Right
Speaker
Front Right
Speaker
Center Channel
Front Left
Speaker
Surround Left
Speaker
Red White
To Dolby Surround
Equipped Receiver
(L+R Audio Input)
Dolby Surround
Connection Example
Yellow
To TV Video Input
Front Right
Speaker
Front Left
Speaker
To Amplifier/Receiver
with Digital Coaxial Input
2 Channel Digital Audio
Connection Example
(Continued on p 11)
Enjoy the dynamic sound of 2 Channel Digital Audio by
connecting an amplifier equipped with a coaxial digital input
(coaxial cable sold separately).
For cinema quality sound, connect the audio cables directly to your home theater equipment for maximum audio enjoyment.