AFX HUS118PCEC-LA - Manual

Limited Factory Warranty
We hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 2
years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure
due to improper installation, misuse, mishandling or damage incurred in transit.
Huron - HUS Series
Fluorescent Wall Sconce
Model 118
Page 1 of 1 8060314 Rev 1
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 110-120VAC, 60Hz fused circuit.
Do not use on a dimming circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended for use in a dry or damp indoor
location.
Assembly Instructions
1. Preparing for installation-
A. Disconnect electrical
power before installing
or servicing any part of
this fixture.
B. Remove shade assembly
(2), and fixture assembly
(6) from cartons. Separate
contents of hardware bag.
2. Mounting-
A. Attach mounting plate (7)
to junction box (not
provided) with two of the
long screws provided (9)
B. Pull supply wires through
the mounting plate.
C. Twist green (or green and
yellow) wire from fixture
with supply ground and
attach to the green ground
screw on the mounting
plate. Tighten ground
screw.
3. Wiring- all wiring must
take place inside junction
box.
Caution: Make sure power is off
at fuse or circuit breaker box.
Check power wires for damage or
scrapes. If power supply wires are
within three inches of ballast use
wire suitable for at least 90C (194F). Note: Most
dwellings built before 1985 have supply wire rated to
60C. Consult a qualified electrician
before installing.
A. Using wire connectors,
connect white supply wire
to white lamp lead.
Connect black hot supply
wire to black lamp lead.
Do not mix wires. Tuck
all connections neatly into
junction box.
B. Line the holes in the
fixture canopy (6) with the
holes on the mounting
plate (7). Insert supplied
screws(8) into threaded
holes in the mounting pan
and tighten securely.
4. Lamp -Install appropriate
lamp (4). Insert lamp pins into
lamp holder (5) and press
downwards until lamp snaps in
place.
5. Shade -To install shade
assembly, align the two holes
in the top of the shade (2) with
the two threaded studs on top
of the harp (3) and secure with
threaded ball nuts (1).
6. Restore power at fuse or circuit
breaker box.