AFX NMS65500L30D1WH-DC - Manual

Noma Series
LED Wall Sconce
Model NMS65
Page 1 of 1 8060777 R0
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water. Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or
servicing any part of this fixture.
B. Remove fixture; place the diffuser assembly (5) off to
the side and locate the bag with hardware.
C. Mount circular gem bar (1) to junction box (not
provided) using provided #8-32 screws
Note – fixture mounting screws (2) need to be installed
in gem bar prior to mounting to junction box
2. Wiring
All wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box.
Check power wires for damage or scrapes. If power supply
wires are within three inches of driver use wire suitable for at
least 90C (194F). Note: Most dwellings built before 1985 have
supply wire rated to 60C. Consult a qualified electrician before
installing.
A. This unit will not operate properly unless connected to
a “grounded” electrical circuit. Electrical shock, over
heating, low or no light output, and shortened lamp life can result if proper grounding is not done. Securely attach green (or
green and yellow) wire to back of fixture with provided hardware.
B. Using wire nuts (provided), connect white (common) supply wire to white fixture lead. Connect black (hot) supply wire to
black fixture lead. Do not mix wires. Pull on each wire lead to make sure connections are secure. Make certain no bare wires
are exposed outside of wire connectors. Note: fixtures with universal voltage power supplies are pre-wired with a
disconnect. Refer to the included guide for using the disconnect
3. Fixture mounting
A. Install wall pan (3) over the mounting screws (2), and secure using ball nuts (4).
Note – adjust mounting screw length if required to make a secure fit
B. If included, install the light divider (7) on the top or bottom of wall pan as desired using #6-32 screws (8)
4. Diffuser assembly installation
A. Slide diffuser assembly (5) over wall pan, and secure in place using the #6-32 flat head screws (6)
B. Restore power at fuse or circuit breaker box.
Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of
5 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not
cover failure due to improper installation, misuse, mishandling or damage incurred in transit.