AFX RIS224SNMV - Manual

RIS Series
Fluorescent Wall Sconce Fixture
Model 124 & 224
Page 1 of 1 8060559 rev.0
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 120-277VAC, 60Hz fused circuit.
Do not use on a dimming circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended for general indoor lighting in dry or damp
locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or servicing any part of
this fixture.
B. Carefully remove glass diffuser(s) (1) from separate packaging.
C. Remove back plate (5) from main housing (3) by removing top and
bottom screws (4).
2. Wiring
All wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box. Check power
wires for damage or scrapes. If power supply wires are within 3 inches of ballast
use wire suitable for at least 90
o
C (194
o
F). Note: Most dwellings built before
1985 have supply wire rated to 60
o
C. Consult a qualified electrician before
installing.
A. This unit will not operate properly unless connected to a “grounded”
electrical circuit. Electrical shock, overheating, low or no light output,
and shortened lamp life can result if proper grounding is not done.
Securely attach green (or green and yellow) wire to green
B. Connect the white supply wire to the white ballast lead. Connect black
supply wire to black ballast lead. Do not mix wires. Pull on each wire
lead to make sure connections are secure. Make certain no bare wires
are exposed outside of wire connectors.
3.
Fixture mounting
A. Mount back plate (5) to junction box using the 2 mounting screws (6)
provided in the parts bag.
B. Position the main housing (3) over the back plate (5). Align holes and
secure using the provided screws (4).
4.
Diffuser installation
A. Install 24W 2G11 base lamp(s) (2) by inserting pins into lamp holder(s) located in the main housing (3) and pressing until
lamp snaps in place.
B. Install diffuser(s) (1) by rotating them clockwise into main housing (3) until they are securely fastened
C. Restore power at fuse or circuit box.
Limited Factory Warranty
American Fluorescent Corporation warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions
for a period of 2 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not
cover failure due to improper installation, misuse, mishandling or damage incurred in transit.