AFX TYS1123213QMVSN - Manual

TYS Series
Fluorescent Wall Sconce
Models 213, 218, & 226
Page 1 of 2 8060610 rev.0
Safety Precautions
Read all safety precautions and installation instructions
carefully before installing or servicing this fixture. Failure to
comply with these instructions could result in potentially fatal
electric shock and/or property damage.
It is recommended that a qualified electrician perform all
wiring. This fixture must be wired in accordance with all
national and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp
surface or in water.
For model with MV at the suffix, this fixture is designed for
use in a 120-277VAC, 60Hz. For models with SCT at the
suffix, this fixture is designed for use in a 120VAC, 60Hz. Do
not use the MV fixture on a dimming circuit. The SCT fixture
is dimmable (Consult with American Fluorescent for GU24
dimmable lamps to use)
To reduce the risk of electrical shock, and to assure proper
operation, this fixture must be adequately grounded. To
accomplish proper grounding, there must be a separate ground
wire (green) or bare metal contact (metal conduit) between
this fixture and the ground connection of your main power
supply panel. The green ground screw location is clearly
marked on the fixture housing.
This fixture is intended for use for general indoor lighting in
dry or damp locations only.
Assembly Instructions
1. Preparing for installation-
A. Disconnect electrical power before installing or servicing any
part of this fixture.
B. Remove shade assembly (1), cast arm assembly (16) and backpan
assembly (7) from cartons. Separate contents of hardware bag.
2. Arm Assembly-
A. Make sure the cover plate (20) is securely assembled with the
finial (22) and be able to mount it with the bracket plate (17).
B. Attach and align the two brackets (14) on the arm assembly with
the backpan (7) bottom holes and secure with the screws (13) and
hex nuts (11) provided.
C. Secure the bottom diffuser (2) by aligning the holes with the
threaded holes on the backpan (7) and secure with the screws (15)
provided.
3. Wiring- all wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box. Check
power wires for damage or scrapes. If power supply wires are within three
inches of ballast use wire suitable for at least 90C (194F). Note: Most
dwellings built before 1985 have supply wire rated to 60C. Consult a
qualified electrician before installing.
A. Attach gem bar (10) to junction box (not provided) with two of
the long screws provided. Install the long threaded stem (8) by
screwing to the gem bar (10).
B. Securely attach green (or green and yellow) wire to bare wire
from junction box.
C. Using luminaire disconnect (provided), insert white supply wire
into the hole across from white ballast lead. Insert black hot
supply wire into hole across from black ballast lead. Do not mix wires. Pull on each wire to make sure connections are
secure. Make certain no bare wires are exposed outside of luminaire disconnect.
D. Tuck all connections neatly into junction box.
FIG 2
FIG 1