AFX ACU16LWH - Manual

ACU Series
Arches LED Undercabinet Fixture
Models 12LWH, 16LWH, & 22LWH
8060643 R4 1 of 1
Limited Factory Warranty
AFX Lighting, Inc. warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of 3
years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure due to
improper installation, misuse, mishandling or damage incurred in transit.
Safety Precautions
Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.
This fixture is designed for use in a 110-120VAC, 60Hz fused circuit.
Do not use on a dimming circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground connection
of your main power supply panel. The green ground screw location is
clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry and
damp locations.
ASSEMBLY INSTRUCTIONS
1. Preparing for installation
A. Disconnect electrical power at fuse or circuit breaker box before
installing or servicing any part of this fixture.
B. Remove fixture from carton.
C. Remove white plastic covers from the front surface.
2. Fixture mounting
A. To locate: mark the desirable location of one of the mounting holes on the cabinet surface. Measure the distance “A” between fixture slotted
holes and mark the second hole location.
B. Drill two 3/32 diameter holes in the marked locations.
C. Install two #8 Wood Screws (included) into the fixture through the front openings-see Figure 1. If the mounting surface is other than a wood,
use suitable screws (not included).
D. Hold the fixture up to the undercabinet surface with power supply located over entryway for power supply wires. Align screws and holes on
the undercabinet surface. Tighten the screws.
E. Caution-Personal injury and damage to the lamp and/or mounting surface may result if the lamp is pulled from the surface. To reduce the
likelihood of injury or damage, mount only on a surface that is structurally sound.
F. Install plastic plugs into the front openings-See Fixture 2.
G. Restore the power at the fuse or the circuit breaker box.
3. Plug in the Power Cord (included).
4. 12” Extension Cable (included) for linking multiple fixtures together. DO NOT LINK more than 80 units for 12”, 64 units for 16” and 40 units for
22” in series.