AFX VOV213SNSCT - Manual

VOV Series
Fluorescent Wall Sconce Fixture
Models 213, 313, 113
Page 1 of 1 8060581 R.2
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 120VAC, 60Hz fused circuit. Do
not use on a dimming circuit.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the fixture housing.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or
servicing any part of this fixture.
B. Carefully remove diffuser (3) from separate packaging.
C. Rotate sections of gem bar (6) to form an X. Install #8-
32 x 1” screws (provided) into center threaded holes in
offset section of gem bar as shown. Screw head to face
flat section of bar. Verify screws line up with holes in
canopy (1) and adjust length to allow for decorative nuts
(2).
2. Wiring.
All wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box.
Check power wires for damage or scrapes. If power supply wires
are within three inches of ballast use wire suitable for at least 90C
(194F). Note: Most dwellings built before 1985 have supply wire
rated to 60C. Consult a qualified electrician before installing.
A. This unit will not operate properly unless connected to a
“grounded” electrical circuit. Electrical shock, over
heating, low or no light output, and shortened lamp life can result if proper grounding is not done. Securely attach green (or
green and yellow) wire to green ground screw on gem bar with provided hardware.
B. Using wire connectors (provided), connect white supply wire to white ballast lead. Connect black hot supply wire to black
ballast lead. Do not mix wires. Pull on each wire lead to make sure connections are secure. Make certain no bare wires are
exposed outside of wire connectors.
3. Fixture mounting.
A. Gem bar mounting – Secure flat section of gem bar (6) to junction box (not supplied) with appropriate screws (supplied).
Rotate offset section of gem bar (6) with pre-attached screws to a horizontal position.
B. Position canopy (1) holes over screws in offset section of gem bar (6) and attach securely with decorative nuts (2).
4. Diffuser installation
A. Mount diffuser (3) by positioning over the decorative cup and screwing the threaded socket into the cup.
B. Install appropriate GU-24 lamps (5) (included) by inserting lamp pins into lamp holder and rotating clockwise until lamp
snaps in place.
C. Restore power at fuse or circuit breaker box.
Limited Factory Warranty
American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 2 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.