Allied Telesis x310 Series - Manual (Page 104)

Chapter 8: Cabling the Networking Ports
104
Cabling the Twisted Pair Ports
Here are the guidelines to cabling the 10/100Base-TX and 10/100/
1000Base-T twisted pair ports:
 The cable specifications for the 10/100Base-TX and 10/100/
1000Base-T twisted pair ports are listed in Table 1 on page 24 and
Table 2 on page 26, respectively.
 The connectors on the cables should fit snugly into the ports, and
the tabs should lock the connectors into place.
 The default setting for the wiring configurations of the ports is auto-
MDI/MDI-X. The default setting is appropriate for switch ports that
are connected to 10/100Base-TX network devices that also
support auto-MDI/MDI-X.
 The default auto-MDI/MDI-X setting is not appropriate for switch
ports that are connected to 10/100Base-TX network devices that
do not support auto-MDI/MDI-X and have a fixed wiring
configuration. For switch ports connected to those types of network
devices, you should disable auto-MDI/MDI-X and set the wiring
configurations manually.
 The appropriate MDI/MDI-X setting for a switch port connected to a
10/100Base-TX network device with a fixed wiring configuration
depends on the setting of the network device and whether the
switch and network device are connected with straight-through or
crossover cable. If you are using straight-through twisted pair
cable, the wiring configurations of a port on the switch and a port
on a network device must be opposite each other, such that one
port uses MDI and the other MDI-X. For example, if a network
device has a fixed wiring configuration of MDI, you must disable
auto-MDI/MDI-X on the corresponding switch port and manually
set it to MDI-X. If you are using crossover twisted pair cable, the
wiring configurations of a port on the switch and a port on a
network device must be the same.
 The default speed setting for the ports is Auto-Negotiation. This
setting is appropriate for ports connected to network devices that
also support Aut-Negotiation.
 The default speed setting of Auto-Negotiation is not appropriate for
ports connected to 10/100Base-TX network devices that do not
support Auto-Negotiation and have fixed speeds. For those switch
ports, you should disable Auto-Negotiation and set the port’s
speed manually to match the speeds of the network devices.
 The 10/100/1000Base-T ports must be set to Auto-Negotiation, the
default setting, to operate at 1000Mbps.
 The default duplex mode setting for the ports is Auto-Negotiation.
This setting is appropriate for ports connected to network devices