Allied Telesis AT-GS950/48 - Manual (Page 226)

Chapter 18: Access Control Configuration
226
Note
The In-Profile Action Index is a required parameter when you create
a Policy. See “Create Policy” on page 236 for more information.
4. Enter a number in the Profile Action ID field ranging from 0 to 72.
This field is mandatory.
Note
This field must be pre-defined on the Create Profile page - see
“Creating a Profile Action” on page 222 for more information.
5. In the Deny/Permit field, use the pull down menu to select one of the
following parameters:
Deny - This selection drops ingress packets that conform to the
specified Profile Action ID.
Permit - This selection allows ingress packets that conform to the
specified Profile Action ID to be processed by the switch.
Note
You must enter a selection for Deny/Permit field even if the Profile
Action ID that you have entered ignores both the Policed-DSCP and
Policed-CoS fields.
6. Click Add.
The In-Profile Action entry is added to the status table. If you do not
see you new entry, you may need to navigate to another page of the
table with the First Page, Previous Page, Next Page, and Last Page
buttons located below the table. An example of an In-Profile Action
table entry is displayed in Figure 83.
Figure 83. Example of In-Profile Action Entry