Allied Telesis AT-GS950/16PS - Manual (Page 32)

Chapter 2: System Configuration
32
IP Access List Configuration
When the IP Access List feature is enabled, remote access to the
AT-S112 management software is restricted to the IP addresses entered
into the IP Access List.
The procedures in this section describe how to enable or disable the IP
Access List feature and how to add or remove IP addresses from the list.
See the following sections:
 “Create an IP Access List” on page 32
 “Delete an IP Address List Entry” on page 33
Note
To modify IP address that has already been created, it must first be
deleted and them re-created using the following procedures.
Create an IP
Access List
To create a list of accessible IP addresses, perform the following
procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select IP Access List. The IP Access List
Page is displayed. See Figure 7.
.
Figure 7. IP Access List Page
3. Enter an IP address in the IP Address field using a xxx.xxx.xxx.xxx
format.
4. Click Add.
The IP address is added to the IP Access List table in the Accessible
IP column.
Note
You can add up to 10 IP address to the IP Access List table.