Allied Telesis AT-GS950/24 - Manual (Page 126)

Chapter 9: Loopback Protection
126
Configuration
To configure the Loopback Detection feature, perform the following
procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select Loopback Detection.
The AT-GS950/24 Loopback Detection Page is displayed. See Figure
42 for a partial view of this page.
Figure 42. AT-GS950/24 Loopback Detection Page
3. For the Loopback Detection State field at the top of the page, select
one of the following radio buttons:
Enabled: This selection enables the Loopback Detection feature
across the switch. This state must be enabled for the individual
port Loopback Detection State to be effective.
Disabled: This selection disables the Loopback Detection feature
on the switch.