Allied Telesis AT-GS950/8 - Manual (Page 270)

Chapter 20: Simple Network Management Protocol SNMPv1 and v2c
270
5. Click Add.
The new Community Name and User Name are displayed.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modify SNMPv1/
v2 Community
Strings
If you need to modify a Community Table entry, you must first delete the
entry by using the procedure below and then re-enter it with the
modification by creating a new Community table entry - see “SNMPv1/v2
User and Group Names” on page 267.
Delete SNMPv1/
v2 Community
Strings
Use the following procedure to delete a community name of an SNMP
community in the Community Table.
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Community Table.
The Community Table Page is shown in Figure 96 on page 269.
3. To delete a Community Name, click Delete next to the entry in the
table that you want to remove.
The deleted Community Name is no longer displayed in the
Community table. No confirmation message is displayed.
4. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.