Powering on the access point, Figure 9: connecting the power adapter38, Chapter 2: installation 38 – Allied Telesis AT-WA7400 User Manual
Page 40
Advertising
Chapter 2: Installation
38
Powering On the Access Point
To power on the access point, perform the following procedure:
1. Do one of the following:
a. Plug the power cord on the adapter into the power connector
on the back panel, as shown in Figure 9, and plug the power
adapter into a wall outlet.
Figure 9. Connecting the Power Adapter
Warning: Do not work on equipment or cables during
periods of lightning activity.4
Warning: Power cord is used as a disconnection
device. To de-energize equipment, disconnect the
power cord. 5
309
5V,2.8
A
RESE
T TO
DEFA
ULT
LAN
Advertising