Allied Telesis AT-S105 - Manual (Page 201)

AT-S105 Management Software Web Browser User’s Guide
201
Upgrading a Firmware Image Using TFTP
This section describes how to upgrade an firmware image of the AT-S105
Management software using TFTP on an TFTP server. Before
downloading a new version of the AT-S105 software onto the switch, note
the following:
ˆ The current configuration of a switch is retained when a new AT-S105
Management software software image is installed. To return a switch
to its default configuration values, see “Returning the AT-S105
Management Software to the Factory Default Values” on page 44.
ˆ Your network must have a TFTP server.
ˆ You must specify the path to the new AT-S105 image file on the TFTP
server.
ˆ Start the TFTP server software before you begin the download
procedure.
Caution
Downloading a new version of management software onto the
switch causes the device to reset. Some network traffic may be lost
during the reset process.
This procedure assumes that you have already obtained the software and
have stored it on the computer from which you will be performing this
procedure.
To download the AT-S105 Management software image onto the switch
using a TFTP server, do the following procedure:
1. From the main menu on the left side of the home page, select the
Tools folder.
This folder expands to show the contents of the Firmware Upgrade
folder.