Allied Telesis AT-CV5001 - Manual (Page 52)

Chapter 2: Installation
52
Installing the AT-CV5M02 Management Card
This section contains the instructions for installing the AT-CV5M02
Management Card.
To install the AT-CV5M02 Management Card, perform the following
procedure:
1. Select a slot in the chassis for the management card. You can install
the card in any slot.
Note
If you are installing a redundant management card into an existing
chassis, you should install it while the chassis is powered on. If the
chassis is powered off, you should install it in a higher numbered slot
than the existing management card. If you install a redundant
management card into a lower numbered slot than the existing card
while the chassis is powered off, the master configuration file of the
new card, which will become the active card, will overwrite the
configuration file on the existing card when you power on the
chassis. If the auto-copy settings in the new master configuration file
is enabled for the chassis slots, the configuration settings of the line
cards may change. For further information, refer to Converteon
AT-S73, AT-S99, AT-S102, Management Software User’s Guide.
Warning: Remove all metal jewelry, such as rings and watches,
before installing or removing a line card from a powered-on
chassis.

E26
Caution Be sure to observe all standard electrostatic discharge
(ESD) precautions, such as wearing an antistatic wrist strap, to
avoid damaging the device. A line card can be damaged by
static electricity.
Note
The AT-CV5001 Chassis does not support the AT-CV5M01
Management Card.