Allied Telesis x600-48Ts/XP User Manual
Installation guide, X600 series layer 3 gigabit ethernet switches
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Preface
- Contents
- List of Figures
- List of Tables
- Chapter 1
- Overview
- Introduction
- Switch Descriptions
- 10/100/1000Base-T Twisted Pair Ports
- SFP Transceiver Slots
- XFP Transceiver Slots
- Redundant Twisted Pair Ports
- SD Card Slot
- Port LEDs
- System Status LEDs
- Stack LEDs
- Terminal Port
- AT-RPS3204 Redundant Power Supply
- AT-LBM (Loop Back) Module
- VCS Stacking Module
- AC Power Connector
- Chapter 2 :
- Virtual Chassis Stacking
- Chapter 3
- Installing the Hardware
- Chapter 4
- Cabling the Network Ports
- Chapter 5
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- SFP or XFP LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Issues with Virtual Stacking Chassis Configuration
- Appendix A
- Technical Specifications