Allied Telesis AT-S99 - Manual (Page 145)

AT-S73 and AT-S99 Management Software User’s Guide
145
Setting the Operating Mode
For background information, refer to “Operating Modes” on page 42.
Caution
This procedure resets a line card, disrupting its normal operations.
Some network traffic may be lost. When an AT-CM Line Card is
reset, it immediately resumes forwarding network traffic. However, it
uses the default values for its parameter settings while it initializes
the management software, which takes approximately one minute.
Afterwards, the card configures its operating parameters from the
settings in its configuration file or from the management card. The
AT-CV Line Cards do not have management software and
immediately resume normal network operations.
Menus
To change the operating modes of the AT-CM and AT-CV Line Cards from
the menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Status and Configuration menu shown in Figure 48
on page 128.
2. From the Module Status and Configuration menu, select the line card
you want to configure. You can configure only one line card at a time.
The Module Configuration Menu in Figure 53 on page 139 is
displayed.
3. From the Module Configuration Menu, select Configure Operating
Mode to display the Operating Mode Config Menu, shown in
Figure 57. The menu lists the available operating modes for the line
card. The AT-CV Media Converter Line Cards do not support the OAM
bypass and OAM visible modes.
Figure 57. Operating Mode Config Menu
Operating Mode Config Menu
Module 4
Smart Missing Link Mode
Missing Link Mode
OAM BYPASS Mode
> OAM Visible Mode
Link Test Mode
Line Card DIP Switch Mode
Return to Module Configuration Menu ...