1 snmp v1 / v2c settings – Allied Telesis AlliedView-EMS 3.10 AMIGO User Manual
Page 26
Port number
The UDP port number on which the target device is listening for SNMP
messages. If the target device is using a non-standard port for SNMP
operations, you must change this value.
SNMP version
The version of SNMP that the device will use to send and receive device
information. After choosing the version of SNMP to use, click on the
Settings button to specify the SNMP parameters that correspond with
the chosen version. If the SNMP version is set to "v1" or "v2c", then the
SNMP v1/v2c Settings dialog box will be displayed. Otherwise, if the
SNMP version is set to "v3", then the SNMP v3 Settings dialog box will be
displayed.
Target Host Property dialog box
4.1.6.3.1 SNMP v1 / v2c Settings
Community for read/Community for write
The community strings used to perform SNMP operations on the device.
AlliedView™-EMS 3.10 AMIGO USERS GUIDE
Page 26 of 43